I am actually not due to go back down to the home until next February… and even that will depend on work. I have gone through three protocol adapters with Pentair - they really need to look at the engineering of their design. I did this because my Pentair brick (appropriately named) failed yet again. I am in an interesting position as I purchased a controller for my vacation home in Phoenix (I live in Toronto). Hello, I was wondering if you might have ever modified this for the gateway. I created this originally so I could for instance put all the pool features on one panel. If you want to create custom panels that incorporate your most used pool features and even create macros using scenes take a look at the Virtual Panel plugin.
After you have configured your pool setup you can then control it like any other device or devices on your system. Again, this is only used to configure the devices. When Vera went to https, the ajax calls to get the config need to be modified to funnel through the gateway. I need to figure out a way to make ajax calls over https only when you are connected remotely. After it is configured the all the devices and controls will work just fine.